data brief for further information contact your local stmicroelectronics sales office. november 2011 doc id 022498 rev 1 1/4 1 L99DZ81EP door actuator driver features one full bridge for 6 a load (r on = 150 m ) one half bridge for 3 a load (r on =300m ) one configurable highside driver for up to 1.5 a (r on = 500 m ) or 0.4 a (r on = 1600 m ) load one configurable high-side driver for 0.8 a (r on = 800 m ) or 0.4 a (r on = 1600 m ) load two high-side drivers for 0.5 a load (r on = 1600 m ) programmable softstart function to drive loads with higher inrush currents as current limitation value very low v s current consumption in standby mode (i s < 6 a typ. t j 85c) current monitor output for all high-side drivers central two-stage charge pump motor bridge driver with full r dson down to 6 v device contains temperature warning and protection open-load detection for all outputs overcurrent protection for all outputs separated half bridges for door lock motor programmable pwm control of all outputs stm standard serial peripheral interface (st- spi 3.0) prepared for additional fail-safe path for h-bridge applications door actuator driver with 3 bridges for double door lock control, 4 high-side drivers for bulb and led control. motor bridge driver to control four external power transistors in h-bridge configuration description the L99DZ81EP is a microcontroller driven multifunctional door actuator driver for automotive applications. up to two dc motors and four grounded resistive loads can be driven with three half bridges and four high-side drivers. four external mos transistors in bridge configuration can be driven. the integrated spi controls all operating modes (forward, reverse, brake and high impedance). also all diagnostic information is available via spi read. * $ 3 * & |